Standard Drawings
Drawing Scale: Drawings are done in a scale of 1 / 4" = 1'- 0"
One set of plans includes:
Exterior Elevations: Shows the front, rear and side of the house including
exterior materials, finishing details, window locations.
Framing Floor Plans Shows the placement of walls and the dimensions for
rooms, doors, windows, stairways, etc. for each level of the house.
Shows the pitch and layout of the roof.
Electrical Schematic: Shows the location of outlets, fixtures and switches,
room sizes, cabinet layouts.
It may be shown as a separate sheet or be included on the floor plan.
Cross Sections: Shows details of the house as if it were sliced from
the roof to the foundation. The cross sections detail the construction of the home,
insulation, flooring and roofing.
Foundation Plans: Shows either a basement, crawlspace or slab
depending on what is available for the plan.
(Please refer to the plan's display page to see what foundation options
are available for a specific plan.)
The foundation plan details the layout and construction of the foundation.
General Specifications: Provides instructions and information about
any combinations of the following: structural specifications, excavating
and grading, masonry and concrete work, carpentry and wood specifications,
thermal and moisture protection, and specifications about drywall, tile, flooring,
glazing, caulking and sealants.
Note: All of our plans are designed to meet or exceed national building code
standards. However, we cannot guarantee that a plan will meet all local code
requirements and variations, please consult with local bylaws.
Due to regional variations it is impossible to include much detail about heating,
plumbing and electrical work. Duct work, venting and other details vary depending
on the type of HVAC system and the type of energy used. These details and specifications
are easily obtained from your builder, contractor or local supplier.
|
|
